30
9
SPECIFICATIONS
General
ï
• Frequency coverage (MHz)
: TX 118.000 to 136.9917
RX 108.000 to 136.9917
*
• Mode
: 6K80A3E/5K00A3E
• Channel spacing
: 25 kHz/8.33 kHz
• Number of memory channels
: 200 (20 CH
×
10 BANK)
• Power supply requirement
: Specified battery packs/case or
11.0 V DC at external DC jack
• Usable temperature range
: –20˚C to +55˚C
• Current drain
:Tx 1.5 A typical
Rx 70 mA typical (at stand by)
300 mA typical
(at AF maximum)
• Antenna connector
: BNC 50
W
(nominal)
• Dimensions
: 54(H)
×
129.3(W)
×
35.5(D) mm
(projections not included)
• Weight
: Approximately 180 g
(Without the battery pack and antenna.)
Transmitter
ï
• Output power
: 5.0 W (PEP) typical
1.5 W (CW) typical
• Modulation
: Low level modulation
• Modulation depth
: 85%
• Audio harmonic distortion
: Less than 10% (at 85% ±3 dB
modulation)
• Microphone connector
: 3-conductor 2.5(d) mm (
1/10˝)/
more than 100 k
W
• Frequency stability
: ±1 ppm
• Harmonics spurious emissions
: Less than –36 dBm (except oper-
ating frequency ±1 MHz range)
Receiver
ï
• Receive system
: Double conversion
superheterodyne
• Intermediate frequencies
: 1st
46.35 MHz
2nd
450 kHz
•
Sensitivity VOR (AM 6dB S/N)
: –3 dBµ typical
COM (AM 12dB SINAD) : –3 dBµ typical (with CCITT)
• Squelch sensitivity
: Less than 0 dBµ (Threshold)
• Adjacent channel rejection
: More than 60 dB
• Spurious response rejection : More than 70 dB
• Audio output power
: 500 mW typical
( at 10% distortion with an 8
W
load, 30% modulation)
• Hum and noise
: More than 40 dB at 90% modula
-
tion
• External speaker connector
: 3-conductor 3.5 (d) mm (
1/8˝)/8
W
*: IC-A24E only. (IC-A6E frequency coverage is from 118.000 to 136.9917
MHz.)
Measurements made in accordance with EN300 676.
All stated specifications are subject to change without notice
or obligation.