15
4
OTHER FUNCTIONS
■
Setting the
frequency step
You can select Frequency steps of 8.33 kHz or 25 kHz in the
menu mode.
q
Hold down
[RCL]
for two seconds to enter the Settings
menu.
w
Rotate
[O-DIAL]
to select “FREQ. STEP.”
e
Rotate
[DIAL]
to select the frequency steps of 8.33 kHz
or 25 kHz.
r
Push
[RCL]
to exit the Settings menu.
CAUTION:
In Canada, use of 8.33 kHz Channel
Spacing of this radio is strictly prohibited and shall not
be used .
■
Using the remote control
You can remotely control the frequency exchange key,
intercom, and recall key by connecting pins 1, 3, and 17
of the D-Sub 25 pin connector on the rear panel to the
switches connected to the power ground.
Refer to “INSTALLATION GUIDE” for details.
• Set the “REM SWAP,” “REM INCOM,” and “REM RECALL” item to
ON in the Configuration menu. See page 24 for details.
■
Scanning the weather
memory channels
Scanning automatically searches for weather channel
signals.
Repeatedly scans all weather memory channels.
You can set the interval time (scan speed) for the scan
in the Settings menu (“DW INTERVAL”). See page 21 for
details.
q
Push
[RCL]
to enter the memory mode, and then rotate
[O-DIAL]
to select the weather memory channel.
w
Hold down
[VOL]
for two seconds to start a weather
memory channel scan.
• “SEARCH” blinks while scanning.
• To change the scan direction, turn
[DIAL]
.
• The scan continues even while receiving a signal on the active
frequency.
162.55
5
122.00
RX
WEATHER
SEARCH
Summary of Contents for IC-A220T
Page 38: ...31 MEMO ...
Page 39: ...32 01 02 03 04 05 06 07 08 09 10 11 12 13 14 15 16 MEMO ...
