Icom IC-7600, Instruction Manual, Page: 118 / 196

■
Memory channel programming
109
6
MEMORY OPERATION
MW
[EXAMPLE]:
Programming 7.088 MHz/LSB into memory channel
12.
Push for 1 sec.
Beep
Beep
Beep
7
3
SSB
MW
or
[EXAMPLE]:
Programming 21.280 MHz/USB into memory channel 19.
Push for 1 sec.
Beep
Beep
Beep
SSB
MW
then or
21
7
Memory channel can be programmed in either the
VFO mode or the memory mode.
D Programming in the VFO mode
q
Set the desired frequency, operating mode and
filter width in the VFO mode.
w
Push
[
∫
]/[
√
] several times to select the desired
memory channel.
• The Memory list screen is convenient for selecting the
desired channel. (p. 108)
• Memory channel contents appear in the memory
channel readout (below the frequency readout).
• “--.---.--” appears if the selected memory channel is a
blank channel (and does not have any contents).
e
Hold down
[MW] for 1 second to program the
displayed frequency, operating mode, etc., into the
memory channel.
D Programming in the memory mode
q
Select the desired memory channel with
[
∫
]/[
√
] in
the memory mode.
• Memory channel contents appear in the memory
channel readout instead of the frequency readout.
• Nothing is displayed if the selected memory channel is
an empty channel.
w
Set the desired frequency and operating mode.
• To program a blank channel, use direct frequency entry
with the keypad or memo pads, etc. (p. 30)
e
Hold down
[MW] for 1 second to program the
displayed frequency and operating mode into the
memory channel.