4
RECEIVE AND TRANSMIT
4-4
Operating CW (Continued)
D
About the CW reverse mode
The CW reverse mode receives signals with a reverse
side CW carrier point similar to voice LSB and USB
modes.
Use when interfering signals are near a desired signal
and you want to reduce the interfering tone.
On the Mode selection screen, touch “CW” to select
q
the CW mode.
After the CW mode is selected, touch “CW” again on
w
the Mode selection screen to toggle between CW
and CW-R modes.
• Check that the interfering tone can be reduced.
D
About keying speed
The transceiver’s internal electronic keyer speed can
be adjusted to between 6 and 48
wpm (words per min-
ute)
.
Push
q
SPEED/PITCH
(
C
) to open the Key speed/CW pitch
adjustment display.
Rotate [M-CH]
w
(
L
) clockwise to increase keying
speed; counterclockwise to decrease it.
Push
e
MENU
(
C
) to close the display.
D
About CW pitch control
The received CW audio pitch can be adjusted to suit
your preference without changing the operating fre-
quency.
Push
q
SPEED/PITCH
(
C
) to open the Key speed/CW pitch
adjustment display.
Rotate [BANK]
w
(
L
) to suit your preference.
• Adjustable from 300 to 900 Hz (in 5 Hz steps).
Push
e
MENU
(
C
) to close the display.
Key speed adjustment
CW pitch adjustment
Carrier point
The CW carrier point is set to the LSB side by de-
fault, the setting can be changed to USB side in the
“CW Normal Side” item of the “Function” Set mode.
(p. 17-21)
SET
(
C
) > Function >
CW Normal Side
L
eft
R
ight
C
enter
D
isplay
BFO
CW-R mode (USB side)
BFO
Desired signal
CW mode (LSB side)
Interference
Desired signal
Interference
The
L
,
R
,
C
or
D
in the
instructions indicate the
part of the controller.
L
: Left side
R
: Right side
C
: Center bottom
D
: Display (Touch screen)
Previous view