Icom IC-705, Basic Manual

Page: 57 / 96

8-4
BASIC MANUAL
SET MODE
8
8
Max TX Power (Battery Pack)
(Default: 5W)
Sets the maximum transmit power when using a
battery pack to 0.5, 1, 2.5, or 5 W.
Max TX Power (DC 13.8 V)
(Default: 10W)
Sets the maximum transmit power when
connecting an external DC power supply to 0.5,
1, 2.5, 5, or 10 W.
» SET > Function
> TX Delay
HF (Default: OFF)
50M (Default: OFF)
144M (Default: OFF)
430M (Default: OFF)
Sets the TX delay time on each band.
L
If an external equipment’s rise time is slower than
that of the IC-705, a reflected wave is produced,
and it may damage the IC-705 or the external
device. To prevent this, set the appropriate delay
time so that no reflected wave or timing damage
occurs.
L
Select “OFF” for no delay.
Delay time (ms)
SEND
Po
Rx
Tx
0 10
» SET >
Function
Time-Out Timer (Default: 5min)
Sets the Time-out Timer to OFF, 3, 5, 10, 20, or
30 minutes to prevent an accidental prolonged
transmission.
L
Select “OFF” for no time limit.
PTT Lock (Default: OFF)
Turns the PTT Lock function ON or OFF.
To prevent accidental transmissions, this
function inhibits all transmissions.
•OFF: Turns OFF the function.
•ON: Inhibits all transmissions.
» SET > Function >
SPLIT
Quick SPLIT (Default: ON)
Turns the Quick SPLIT function ON or OFF.
This function automatically turns ON the SPLIT
function, and sets the frequency and mode to
the VFO that is not displayed (VFO A or AFO B),
according to the SPLIT Offset setting.
•OFF: Turns OFF the function.
•ON: Turns ON the function.
SPLIT Offset
(Default: 0.000 MHz)
Sets the SPLIT offset between -9.999 and
+9.999 MHz. The SPLIT offset is the difference
between the receive and transmit frequencies
for the Quick SPLIT function.
SPLIT LOCK (Default: OFF)
Turns the Split Lock function ON or OFF.
The SPLIT LOCK function enables you to adjust
the transmit frequency while holding down ,
even while the Dial Lock function is activated.
To prevent accidentally changing the receive
frequency by rotating , use both the
SPLIT LOCK and Dial Lock functions (p. 3-8).
•OFF: Turns OFF the function.
•ON: Turns ON the function.
» SET >
Function
Tuner (PTT Start) (Default: ON)
Turns the PTT Start Tuning function ON or OFF.
This function starts tuning when [PTT] is pushed
if the operating frequency is shifted* while the
antenna tuner is ON.
* 1.9 ~ 10 MHz band: more than 0.5%
14 ~ 50 MHz band: more than 1%
Auto Repeater (Default: ON (DUP))
L
This item is displayed in only the USA version.
The Auto repeater function automatically turns the
duplex operation and tone encoder ON or OFF.
•OFF: Turns OFF the function.
•ON (DUP): Turns ON the duplex
settings only.
•ON (DUP, TONE): Turns ON the duplex
settings and the tone
encoder function.
RTTY Mark Frequency (Default: 2125)
Selects the RTTY mark frequency.
L
When the internal RTTY decoder is used, 2125 Hz
is automatically selected.