7
1
INSTALLATION AND CONNECTIONS
New2001
New2001
BASIC MANUAL
■
Installing the UT-137
When you install the optional UT-137 Bluetooth
®
unit in
the transceiver, you can communicate with other Bluetooth
device.
1. Turn the transceiver upside-down.
2. Remove the four screws from the bottom of the
transceiver and the four screws from the sides, then lift
off the bottom cover.
WARNING! BE SURE
to disconnect the DC power cable
before starting the following procedures.
NOTE:
Before touching the transceiver or UT-137, remove
static electricity from your body by touching a grounded
object such as a doorknob or aluminum sash. The static
electricity may damage the transceiver or the UT-137, or
cause data lost.
3. Place one end the UT-137 under the edge of the front
panel, with the connector facing down.
4. Carefully, push the connector into the socket.
L
Ensure the UT-137 is installed correctly.
5. Reattach the bottom cover and screws.
Bottom
cover
Front panel
UT-137
Connector
