Installation
17
DOOR ADJUSTMENT
a
DANGER
Incorrect door adjustment with consequent damage to people and property voids the warranty conditions.
Dx
Sx
6
5
4
6
1 2
4
3
1 2
VERTICAL ADJUSTMENT
To make the adjustment:
–
with the door ajar, loosen the counter-nuts (1) of the hinge units
–
act on the adjustment nuts (2) to lift or lower the door by centring the gasket on the stop plate, then block the counter-nuts
(1).
HORIZONTAL ADJUSTMENT
Close the door with the lever (3) and check that the distance between the appliance front plate and the door wall is the same on
both sides. If not:
–
with the door ajar, loosen the locking nuts (4) of the hinge units
–
work on ring nuts (5) to adjust the distance of the door from the appliance front plate
–
tighten the nuts (4) locking the conical washers in the pipes (6).
a
DANGER
When cross-changing ferrules, always make sure that the other two ferrules are fastened, so that they hold the door.
Check the proper adjustment in depth ensuring that the door, manually pushed up to the stop plate, naturally returns remaining
ajar. This is to ensure the hinge side fume seal.
Cooke Industries - Phone: +64 9 579 2185 Email: [email protected] Web: www.cookeindustries.co.nz
