406DUO V1.2.0
Synchronous Balance Charger/Discharger
- 21 -
LiPo/LiIo/LiFe Battery Cycle Setup
Select
Program
→
Cycle
to enter
Cycle
setup interface, after setting click"
" to return to the previous interface.
LiPo/LiIo/LiFe Battery Only Balance Feature
Select
Program
→
Balance Only
to enter
Balance Only
setup interface, after setting click"
" to return to the previous
interface.
Note:
Balance Only
is the program only to equalize the individual cells through balance port to reduce
the voltage difference.
NiMH/NiCd Battery Charge/Discharge Setup
After adding a program, it will switch to NiMH/NiCd battery in
Type
option on the
MEMORY SETUP
interface. Set the
Capacity
, the number of
Cells
for NiMH/NiCd battery cannot be set, and the charger sets
Auto
by default, after editing
all parameters for the program, click"
" to save and return to the previous interface.
As shown in above picture, the program of NiMH, NiCd has the following modes:
Charge, Discharge
and
Cycle
.
NiMH/NiCd Battery Charge Setup
Select
Program
→
Charge to
enter
Charge
setup interface.
Note: Charge Mode has
Normal and Reflex
modes available; use reflex mode to charge the battery, it
can reduce the heat in the battery; please see charging principle on Page38
Cycle Mode
:
CHG
→
DCHG(default),DCHG
→
CHG
，
CHG
→
DCHG CHG, DCHG
→
CHG DCHG,
CHG
→
DCHG STO, DCHG
→
CHG STO
Cycle Count:
1-99; default: 3
Delay Time:
0Min-9999Min; default: 3Min
Chg Current:
0.05A-40A; default: 2A
Chg Mode:
Normal (default), Reflex
