308DUO V1.1.0
Synchronous Balance Charger/Discharger
- 15 -
Press
STATUS-x
button for
2 seconds
when running program to pop up
MODIFY
interface, to modify the current and
discharge voltage parameters online, as below:
Press
STOP/START-x
button when running program to stop running, and press
STOP/START-x
button again to return to
the initial interface.
Error Messages
During the running program, if the system detects an error, it will stop running the program on the channel immediately
and pop up the red dialog box and the buzzer alarms, as below:
Program Edit
After adding new programs or editing saved programs, the system will enter
MEMORY SETUP
interface. Users can set
or modify the program on this interface.
Note: 1. When editing the program name, the character can be selected by turning the
Knob
,
and
clicking the
Knob
to confirm the selected character. Clicking
TAB/SYS
button will delete the
character. If the program name is empty, the system will name it automatically.
2. If the Editing program is the built-in program, the program name and battery type etc.
parameters cannot be changed.
After setting the basic parameters of a battery, click "
"
to enter
MEMORY OPTION
interface, after setting click
“
” to return to
MEMORY SETUP
, and click “
” to save.
1: Error number
2: Error message
See all details on
Page41
1: Program name 2: Battery type
3: Number of cells 4: Battery capacity
5: Available program
Channel Mode:
Asynchronous (default);
Synchronous
Run Counter:
0-999; default: 0
Log Interval:
0.5-60Sec; default: 1Sec
2
1
5
2
3
4
1
