10
ICC
4.
Precautions and Specifications
Rotating shafts and electrical equipment can be hazardous.
Installation, operation, and maintenance of the gateway shall be
performed by
Qualified Personnel
only.
Qualified Personnel
shall be:
•
Familiar with the construction and function of the gateway, the
equipment being driven, and the hazards involved.
•
Trained and authorized to safely clear faults, ground and tag
circuits, energize and de-energize circuits in accordance with
established safety practices.
•
Trained in the proper care and use of protective equipment in
accordance with established safety practices.
Installation of the gateway should conform to all applicable
National Electrical Code
(NEC)
Requirements For Electrical
Installation
s, all regulations of the
Occupational Safety and
Health Administration
, and any other applicable national,
regional, or industry codes and standards.
DO NOT
install, operate, perform maintenance, or dispose of this
equipment until you have read and understood all of the following
product warnings and user directions. Failure to do so may result in
equipment damage, operator injury, or death.
4.1
Installation Precautions
•
Avoid installation in areas where vibration, heat, humidity, dust,
metal particles, or high levels of electrical noise (EMI) are
present.
•
Do not install the gateway where it may be exposed to
flammable chemicals or gasses, water, solvents, or other fluids.
•
Where applicable, always ground the gateway to prevent
electrical shock to personnel and to help reduce electrical noise.
Note:
Conduit is not an acceptable ground.
•
Follow all warnings and precautions and do not exceed
equipment ratings.
