17
8.2 Switch on the tonometer
PRECAUTION!
The tonometer switches off the display when it has not detected any
movement for 15 seconds. The tonometer switches off automatically if it has not been
used for 3 minutes.
Make sure that the date and time shown on the display are correct. If they
are incorrect, update them from the tonometer’s settings or by connecting
the tonometer to the iCare PATIENT2 application or to the iCare EXPORT
software.
Press down
until you hear a beep. The text “Start” is shown on the
display.
OR
3
s
3
s
Alternatively,
press down until you hear a beep. Then press again to
enter the measurement mode. The text “Start” is shown on the display.
8.3 Find the correct measurement position
The forehead support A rests on your forehead and the cheek support B
rests on your cheek.
START
90°
Look straight ahead and the tonometer is at a 90-degree angle to your
face. The probe is about 5 mm (3/16 inches) from your eye and points
perpendicularly to the center of your eye.
NOTE:
The tonometer measuring button should point upwards.
Summary of Contents for HOME2
Page 1: ...ENGLISH Instruction Manual iCare HOME2 Rx Only U S...
Page 47: ...47...
