13
IR Motorized Zoom Lens Series Non-IR Series IR Manual Zoom Series
Figure 3-2 General installation
Step 1
Take the installation position map from the accessories bag and then paste it on the installation ceiling
or the wall according to the monitor area. Please dig three bottom holes of the plastic expansion bolts
according to the map. Take three expansion bolts from the accessories bag and then insert them to the
holes you just dug and then fix firmly. If you need to dig a hole to pull through the cable, you need to dig
a cable exit hole (The diameter is more than 28mm) on the installation surface according to the
installation positioning map.
Step 2
Use the inner hex wrench from the accessories bag to unfasten the 3 hex screws on the dome camera
enclosure to open it.
Step 3
Please remove the device cable (Provided) network port and the power terminal. Use the inner hex
wrench (Provided) to remove the 2 inner hex screws from the dome driver module. Then please follow
the prompt on the device to push the metal hook to two sides. Remove the dome driver module from the
chassis. See Figure 3-3.
