Passenger Control
SYSTEM ACTIVATION
Normal student pickup / drop off operation of the bus will
automatically activate the system. For test purposes, however,
this can also be simulated by the following procedure:
1.
Start the bus or simply turn the ignition key to the ON
position.
2.
Activate the RED flashers.
3.
Open the door (if not already opened).
4.
Close the door to turn OFF the RED flashers.
5.
The Post-Trip Inspection system will then be triggered
(instrument panel gauge cluster will beep and headlights
will flash) when the ignition switch is turned to the OFF
position for longer than half a second.
SYSTEM DEACTIVATION
To deactivate the Post-Trip Inspection
(No Student Left
Behind)
system once the system is triggered, the following
steps must be performed within 60 seconds (to avoid horn
honking):
1.
Turn the key to the ACC (Accessory) position and set
the parking brake.
2.
As you proceed to the rear of the bus, check for children
that may be still on the bus. When you reach the rear of
the bus, lift then lower the rear emergency door lever.
If this bus is equipped with the post-trip inspection
RESET BUTTON (located above the last window on
the driver-side) press and release the reset button.
3.
The system is now deactivated, and the instrument
panel gauge cluster beep, headlights and horn should
now be off.
4.
Move the key to the OFF position. Remove the key if
exiting the bus.
SNOOZE MODE
NOTE: The snooze function can be turned OFF before the
snooze time out period by placing the ignition switch to the
OFF position.
This function allows the driver to temporarily disable the No
Student Left Behind system activation, and is called the Snooze
mode. The purpose is to allow passengers to disembark the
vehicle without the No Student Left Behind system triggering
the vehicle alarm.
This alternate operation allows the driver to turn OFF the engine
while passengers enter or leave the vehicle.
Snooze Mode Initiation Procedure.
To initiate the
snooze feature, proceed and observe the following:
1.
First, with the engine turned off, place the
ignition switch to the ON or ACC (Accessory)
position.
2.
Press and release the SNZ / NO STDNT
LEFT switch to the SNZ position.
68
Summary of Contents for Gasoline CE Series
