![background image](http://html2.mh-extra.com/html/ic-bus/ce-series/ce-series_operation-and-maintenance-manual_3301627121.webp)
Operation
NOTE: If fuel door is opened while vehicle is stationary and
the engine is running, the engine will shut down. If the fuel
door is open while trying to start the engine, the engine will
not start.
1.
Key Switch
2.
Key Position
NOTE: When the ignition switch is in the ON position,
the brake system motor / pumps may be heard as they
run briefly to maintain pressure in the system see the
brake section (Hydraulic Brakes, page 115) for a complete
description.
1.
Apply the parking brake.
Place the transmission in
the Neutral position. Turn OFF the headlights and all
accessories.
2.
Turn ignition switch to ON. The WAIT TO START lamp
will illuminate.
Do not crank engine while lamp is
illuminated.
3.
Once the WAIT TO START lamp is no longer illuminated,
turn the key to the START position.
4.
Do not press the accelerator when starting the engine.
5.
When the engine starts, release the key.
6.
Monitor idle speed. Low idle speed is 750 - 850 rpm.
Check all gauges during warm-up.
7.
For minimum oil pressure at idle, refer to the Engine
Operation and Maintenance Manual. If oil pressure is
too low, the low oil pressure warning lamp may illuminate
along with an AMBER lamp.
8.
During normal engine operation the low oil pressure
lamp will illuminate if minimum oil pressures are not
met. If the lamp remains illuminated for an extended
period of time, a derate may occur.
NOTE: If the engine starts and then stops, repeat engine
starting procedure.
If more than three attempts are
required, contact your nearest service center to schedule
service.
Engine Features
HD-OBD Overview
The HD-OBD system uses many individual pre-programmed
“monitors” to ensure the vehicle is meeting emissions standards.
An HD-OBD monitor is a strategy to evaluate the performance
of an emissions related system or component.
All monitors
are designed for execution in a prescribed frequency; some
monitors run continuously, while some run a specific ratio
against the number of drive cycles.
109
Summary of Contents for CE Series
