IC Bus CE Series 2020, Operation And Maintenance Manual

Page: 31 / 287

Vehicle Inspection Guide
Underhood and Fluid Checks
Component Description
Belts
Open the hood and check that the water pump, alternator, and A/C compressor belts are not frayed and
have no excessive cracking, loose fibers, or other signs of wear. Ensure they are snug and secure.
Fan Cooling Ring and Shroud Check for security of engine-mounted fan cooling ring and fan shroud.
Engine Oil
Use the engine oil dipstick to verify that the engine oil level is correct. Refer to the engine manual for the
correct fluid and lubricant specifications.
Automatic Transmission Fluid
With the engine running, use the dipstick to ensure the correct transmission fluid level is present. Refer to
the
Allison Transmission Manual for correct fluid and lubricant specifications.
Engine Coolant
Ensure the fluid is between the ADD and MAX fluid level range as marked on the reservoir. Do not remove
the pressure cap until the coolant has cooled; failure to do so may result in personal injury. If additional fluid
is necessary, see the Maintenance section of this manual to find the correct fluid type before filling.
Windshield Washer System Fluid
Inspect the fluid level through the plastic reservoir. If additional fluid is necessary, only use windshield
washer fluid.
Power Steering Fluid
Check that the fluid is between the MIN (COLD) and MAX (HOT) marks. If additional fluid is necessary, see
the Maintenance section of this manual to find the correct fluid type before filling.
Brake Fluid Check
Check to ensure the brake fluid is between the MIN and MAX lines. If additional fluid is necessary, see the
Maintenance section of this manual for the correct fluid type before filling.
Radiator and Charge Air Cooler Inspect the radiator and charge air cooler for damage and / or blockage. Inspect all radiator and heater hoses.
Hood and Hood Latches Close and latch the hood. Check that the hood is securely latched in place with the hood latches.
17