IC Bus BE Series, Operation And Maintenance Manual

Page: 36 / 239

Instrumentation
Warning Indicators
The instrument panel gauge cluster may contain as many as 25
individual LED warning indicators. These indicators are used
to alert the driver of vehicle conditions and functions and may
indicate a WARNING or STOP condition. They are turned on by
the software in the instrument panel gauge cluster. At ignition,
the warning indicators will illuminate for 8 to 10 seconds, as part
of the vehicle power-up sequence.
Item
No.
Item Description
1 Optional Wait to Start Lamp
• Illuminates YELLOW when the
propane autogas lines perform a
purge cycle.
2 Not Used
3 Illuminates YELLOW . Used in
conjunction with other Warning indicators
or General Text and Warning Messages
and may be accompanied by an audible
alarm to indicate an Alert condition to the
operator.
4 AWL-The AMBER Warning Lamp (AWL)
illuminates when the vehicle needs to be
serviced at the first available opportunity.
5 RSL-The RED Stop Lamp illuminates
RED when a serious problem has
occurred. This lamp is accompanied by
a message on the odometer display and
an AUDIBLE ALARM. If the RED Stop
Lamp illuminates, immediately pull the
vehicle safely off the roadway, turn on
the flashers, set the parking brake, place
warning devices, and stop the engine.
The engine should not be restarted prior
to being serviced.
6 Illuminates RED when a failure in the
service brake system has occurred. If
the Brake Pressure warning indicator
illuminates, safely stop the vehicle as
soon as possible and seek service
immediately.
7 Illuminates RED when the parking brake
is applied. If the brake warning indicator
does not illuminate, or if it stays on with
the parking brake not engaged, seek
service immediately.
8 Illuminates when the emergency exit is
not securely closed when the key switch
is in the Accessory or ON position.
24