IC Bus BE Series, Operation And Maintenance Manual

Page: 30 / 239

Vehicle Inspection Guide
Interior Visual and Operational Checks
Table 5 Interior Visual and Operational Checks
Interior Mirror Make sure the interior mirror is clean and adjusted to provide a clear view of the entire rear of the bus
including the rear windows. To adjust the mirror, loosen the bolts and nuts in the slotted holes. After moving
the mirror to the desired position, tighten the bolts and nuts.
Window Operation Make sure windows are free of dirt, fog, condensation and snow. Make sure the driver and passenger
windows can open and close completely.
For engine starting procedures, reference (Starting Procedures, page 107). Engine Starting
NOTE: All remaining checks are to be performed with the engine running.
Instrumentation With engine running, check gauges for oil pressure, temperature, alternator, and fuel levels.
Wiper Blades Look through the windshield to inspect both wipers for signs of wear, damage, or signs of aging on the
rubber blades. Check wiper operation.
Passenger Entry Make sure the door opens and closes completely. Make sure the entry steps are clear, and the treads
are secure and are in good condition.
Heater Leaks / Fans Inspect for interior heater fluid leaks and check fan operation at all heater locations.
Emergency Devices Sound the horn. Turn on the heater and defroster. Check the windshield wipers and washers for proper
operation. Using cross-view mirrors and another person, or the lamp check system, verify that the front and
rear exterior directional signal lights are working. Make sure that all interior lights are working properly.
18