ic audio GmbH
Boehringerstraße 14a; D-68307 Mannheim; Germany
Fon: + 49(0) 621 / 77096-0; Fax: + 49(0) 621 / 77096-26
E-Mail: [email protected]; www.ic-audio.com
EN
7
7. Rear Panel
16
.
Power Switch
Press rocker switch to switch on the unit. Press again to switch off the unit.
17. AC Line Voltage Selector.
Set the slide switch to select the AC Line voltage (115V/230V AC).
Note: Never set the switch to wrong AC Line voltage, it will cause damage to the unit.
18. AC Inlet
To plug in the AC power cord.
19. AC Line Fuse Bracket
Insert fuse to the fuse bracket to provide protection for over current.
Note: Always use fuse with correct current and voltage rating.
20. Chassis Ground
A Chassis Ground should be connected during installation
21. DC 24V Input Terminal
Input terminal to connect DC 24V power source.
Note: Never connect to the wrong polarity of DC power source.
22. Direct Output Terminals
Direct Speaker output terminal voltage are 0 – 8
Ω
-70V-100V.
This is unable to be switched when other ZONE outputs are selected.
23. Power Remote ON/OFF Terminal
The unit is able to power ON by Remote control terminal when the unit is under power switch
“OFF”state.
When connecting 24V DC to the Power ON/OFF terminal, the unit will be triggered to power “ON”.
If the unit is switched to power “ON”, this Remote Power ON/OFF terminal cannot control the unit. When
the unit is operated by DC source, it cannot be controlled by Remote Power terminal.
MT-AMP 1000
ic audio
