IBM xSeries 440 8687, Option Installation Manual

Page: 36 / 80

24
xSeries 440:Option Installation Guide
Installing or replacing a drive
In this section, you will find the instructions needed to install or replace a hot-swap
hard disk drive, diskette drive, CD-ROM drive, and DVD-ROM drive.
Hot-swap hard disk drive
Complete the following steps to install or replace a hot-swap hard disk drive:
Attention: When you handle static-sensitive devices, take precautions to avoid
damage from static electricity. For details on handling these devices, see “Handling
static-sensitive devices” on page 10.
1. Inspect the drive for any signs of damage.
2. Review the information in “Before you begin” on page 9 and “Safety Information”
on page 11.
3. Check the instructions that come with the drive for more information about install-
ing your drive.
4. Remove the filler panel or defective hard disk drive from the hard disk drive bay.
5. Install the new hard disk drive in the drive bay:
a. Ensure that the handle on the hard disk drive tray is in the open position.
b. Slide the drive into the bay until it stops.
c. Push the handle on the front of the hard disk drive closed.
6. If you have other options to install or remove, do so now.
Filler panel
Flashing green
light indicates
drive activity
Solid amber
light indicates
failed drive
Flashing amber
light indicates
drive rebuild.