IBM xSeries 440 8687, Option Installation Manual

Page: 28 / 80

16
xSeries 440:Option Installation Guide
Opening the cover
Complete the following steps to open the server cover:
1. Review the information in "Working inside a server with power on" and “Before you
begin” on page 9.
2. Slide the server out from the rack.
3. Pull the release latch on the left half of the top cover to the right.
4. Using the finger hole in the release latch, open the left half of the cover; then,
open the right half of the cover.
Attention: For proper cooling and airflow, close the cover before turning on the
server. Operating the server for extended periods of time (over 30 minutes) with
the cover open might damage server components.
Removing and replacing the bezel
Complete the following steps to remove and replace the server bezel:
1. Remove the bezel.
a. Press on the two tabs at the top edge of the bezel, and pull the top of the
bezel slightly away from the server.
b. Press on the two tabs at the bottom edge of the bezel, and pull the bezel off
the server. Store the bezel in a safe place.
2. Replace the bezel.
a. Align the four tabs with the slots in the server chassis.
b. Press firmly against the front of the bezel until it snaps into place.
NO
TE
:
FO
R P
RO
PE
R A
IR
FLO
W,
RE
PL
AC
E F
AN
W
IT HIN
2
MIN
UT
ES
FR
ON
T O
F B
OX
NO
TE:
FO
R P
RO
PE
R AI
RF
LO
W,
R
EP
LA
CE
FA
N
W
ITH
IN
2 M
IN
UT
ES
FR
ON
T O
F B
OX
Latch