IBM xSeries 440 8687, Hardware Maintenance Manual

Page: 73 / 258

Verifying scalability and RXE cabling
This section describes the procedure to verify scalability and RXE cabling on a
16-way configuration. Begin the procedure by viewing the connections in each
8-way system:
From the diagnostic program main menu, select
1. Hardware Info
2. Summit Chips
A screen similar to the following is shown:
================================================================================
This_______ Connectd_to Ext Is Has Port Trans Recei Error
no Chip_._Port Chip_._Port Int Ready Cable Speed Error Error Count
-- ----------- ----------- --- ----- ----- ----- ----- ----- -----
Scalability:
01 Scalab_1.P1 ........... Ext yes yes 1600 MHz no no 00
02 Scalab_1.P2 ........... Ext yes yes 1600 MHz no no 00
03 Scalab_1.P3 Scalab_2.P3 Ext yes yes 1600 MHz no no 00
04 Scalab_2.P1 ........... Ext yes yes 1600 MHz no no 00
05 Scalab_2.P2 ........... Ext yes yes 1600 MHz no no 00
06 Scalab_2.P3 Scalab_1.P3 Ext yes yes 1600 MHz no no 00
Memory:
07 Memory_1.P0 PCI-X__1.P0 Int yes yes 1000 MHz no no 00
08 Memory_1.P1 PCI-X__2.P0 Int yes yes 1000 MHz no no 00
09 Memory_2.P0 PCI-X__2.P1 Int yes yes 1000 MHz no no 00
10 Memory_2.PB ........... Ext yes no 250 MHz no no 00
PCI-X:
11 PCI-X__1.P0 Memory_1.P0 Int yes yes 1000 MHz no no 00
12 PCI-X__1.PA ........... Ext yes yes 250 MHz no no 00
13 PCI-X__2.P0 Memory_1.P1 Int yes yes 1000 MHz no no 00
14 PCI-X__2.P1 Memory_2.P0 Int yes yes 1000 MHz no no 00
===============================================================================
Diagnostics
61