IBM xSeries 440 8687, Hardware Maintenance Manual

Page: 16 / 258

Features and specifications
The following table provides a summary of the features and specifications for each
xSeries 440.
Microprocessor:
v Supports the following
microprocessors (depending on
your configuration):
– Up to 8 Intel
™
Xeon MP
microprocessors
OR
– Up to 4 Intel Xeon DP
microprocessors
Note: Use the Information in BIOS
to determine the type and speed of
the microprocessors installed in
your server.
v IBM XA-32 chip set with integrated
memory, I/O, system cache, and
remote I/O controllers
Memory:
v Minimum: 2 GB
v
Maximum: 32 GB (depending on
your configuration)
v
Type: 4-way interleaved PC133
MHz, ECC SDRAM, registered
DIMMs only
v Supports 512 MB and 1GB dual
inline memory modules (DIMMs)
v XceL4 Server Accelerator Cache
(up to 64 MB depending on your
configuration)
Drives:
v
Diskette: 1.44 MB
v CD-ROM: 24X IDE
v
Supports up to two internal
Ultra160 SCSI hard disk drives
Active
™
PCI-X expansion slots:
Six 64-bit Active PCI-X expansion
slots:
v Two 66 MHz PCI-X slots
v Two 100 MHZ PCI-X slots
v Two 133 MHZ PCI-X slots
v Additional PCI-X slots available in
an optional remote I/O expansion
enclosure (models 1RX, 2RX, 3RX,
4RX, 5RX, 6RX, 7RX, 3RY, 4RY
only)
Power supply:
Two hot-swap power supplies (550
watts at 110 V ac or 1050 watts at
220 V ac)
Cooling:
Four hot-swap fans
v
Two 150 mm x 51 mm redundant
fans
v Two 150 mm x 38 mm fans
Video:
v S3 Savage4 Pro video on system
board
v PCI bus interface
v Compatible with SVGA
v 8 MB SDRAM video memory at
125 MHz
Size (4U):
v
Height: 17.8 cm (7 inches, 4U)
v
Depth: 69.85 cm (27.5 inches)
v Width: 48.3 cm (19 inches)
v Maximum weight: 50 kg (110 lb)
depending on your configuration
Integrated functions:
v Broadcom 5700 10/100/1000
Ethernet controller
v
Light path diagnostics
v Adaptec 7899W Dual Ultra160
SCSI controller
v Remote Supervisor Adapter
(service processor)
– ASM interconnect
(peer-to-peer) port
– Ethernet port
– Serial port
v IDE controller
v RXE Management Port
v Three USB ports
v Keyboard port
v SCSI port
v Mouse port
v
Symmetrical multiprocessor (SMP)
Expansion Ports (up to six ports
depending on your configuration)
v Two remote I/O expansion
enclosure (RXE) Expansion Ports
Acoustical noise emissions:
v Sound power, idling: 6.2 bel
maximum
v Sound power, operating: 6.2 bel
maximum
Environment:
v
Air temperature:
– Server on: 10° to 35°C (50.0° to
95.0°F). Altitude: 0 to 914 m
(2998.7 ft)
– Server on: 10° to 32° C (50.0° to
89.6° F). Altitude: 914 m (2998.7
ft) to 2133 m (6998.0 ft)
– Server off: -40° to 60° C
(-104° to 140° F). Maximum
altitude: 2133 m (6998.0 ft)
v Humidity:
– Server on: 8% to 80%
– Server off: 5% to 100%
Heat output:
Approximate heat output in British
thermal units (Btu) per hour
v
Minimum configuration: 855 Btu (250
watts)
v Maximum configuration: 2726 Btu
(800 watts)
Electrical input:
v Sine-wave input (47-53 or 57-63 Hz)
required
v Input voltage low range:
– Minimum: 100 V ac
– Maximum: 127 V ac
v
Input voltage high range:
– Minimum: 200 V ac
– Maximum: 240 V ac
v Input kilovolt-amperes (kVA)
approximately:
– Minimum: 0.250 kVA
– Maximum: 0.800 kVA
4
xSeries 440 Type 8687: Hardware Maintenance Manual