IBM xSeries 440 8687, Hardware Maintenance Manual

Page: 153 / 258

Media bay card
Complete the following steps to remove the media bay card.
Note:
v Read “Installation guidelines” on page 71.
v
Read the safety notices at “Safety notices (multi-lingual translations)” on
page 205.
v Read “Handling electrostatic discharge-sensitive devices” on page 204.
1. Turn off the server (see “Turning off the server” on page 11) and disconnect all
power cords and external cables.
2. Open the cover (see “Opening the cover” on page 72).
3. Remove the DASD backplane (see “DASD backplane” on page 140).
Note: The illustrations in this document might differ slightly from the hardware
being serviced.
Finger holes
Latches
4. Insert your fingers in the two thumbholes and push toward the outside edges of
the card until the card is released.
5. Pull the card out of the server.
6. To replace the media bay card, reverse the previous steps.
FRU information (service only)
141