IBM xSeries 440 8687, Hardware Maintenance Manual

Page: 136 / 258

Thermal grease
This section contains information about removing and replacing the thermal grease
between the heat sink and the microprocessor. The thermal grease must be
replaced anytime the heat sink has been removed from the top of the
microprocessor and is going to be reused, or when debris is found in the grease.
Note:
v Read “Installation guidelines” on page 71.
v
Read the safety notices at “Safety notices (multi-lingual translations)” on
page 205.
v Read “Handling electrostatic discharge-sensitive devices” on page 204.
Complete the following steps to replace damaged or contaminated thermal grease
on the microprocessor and heat sink.
1. Place the heat sink on a clean work surface.
2. Remove the cleaning pad from its package and unfold it completely.
3. Use the cleaning pad to wipe the thermal grease from the bottom of the heat
sink.
Note: Be sure that all of the thermal grease is removed.
4. Use a clean area of the cleaning pad to wipe the thermal grease from the
microprocessor; then, dispose of the cleaning pad after all of the thermal grease
is removed.
Microprocessor
0.01 mL of
thermal grease
5. Use the thermal grease syringe to place 16 uniformly spaced dots of 0.01mL
each on the top of the microprocessor.
Note: 0.01mL is one tick mark on the syringe. If the grease is properly applied,
approximately half (0.22mL) of the grease will remain in the syringe.
6. Install the heat sink onto the microprocessor as described in “Microprocessors”
on page 95.
124
xSeries 440 Type 8687: Hardware Maintenance Manual