IBM xSeries 230 6RY, Hardware Maintenance Manual

Page: 145 / 194

Error Code/Symptom FRU/Action
1302 (I
2
C cable from system board to power
on and reset switches not found)
1. Cable
2. Power Switch Assembly
3.
System Board
1303
(I
2
C cable from system board to power
backplane not found)
1. Cable
2. Power Backplane
3. System Board
1304 (I
2
C cable to diagnostic LED board not
found)
1. Cable
2. Diagnostic LED Board
3. Power Switch Assembly
4. System Board
1600 (The Service Processor is not
functioning) Do the following before
replacing a FRU:
1. Ensure that a jumper is not installed on
J51.
2.
Remove the ac power to the system, wait
20 seconds; then, re-connect the ac power.
Wait 30 seconds; then, power-on the
system.
1. System Board
1601 (The system is able to communicate to
the Service Processor, but the Service
Processor failed to respond at the start of
POST.) Do the following before replacing a
FRU:
1.
Remove the ac power to the system, wait
20 seconds; then, re-connect the ac power.
Wait 30 seconds; then, power-on the
system.
2. Flash update the Service Processor.
1. System Board
1762 (Fixed Disk Configuration error)
1. Fixed Disk Cables
2. Run Configuration/Setup 2
3. Fixed Disk Adapter
4. Fixed Disk Drive
5. SCSI Backplane
6. System Board
178X (Fixed Disk error)
1. Fixed Disk Cables
2.
Run Diagnostics
3.
Fixed Disk Adapter
4.
Fixed Disk Drive
5. System Board
1800 (No more hardware interrupt available
for PCI adapter)
1. Run Configuration/Setup
2. Failing Adapter
3. System Board
Symptom-to-FRU index
137