IBM X3850 X6, Installation And Service Manual, Page: 314 / 1730

Removing the shuttle
Use this information for instructions on how to remove the chassis shuttle.
About this task
To remove the chassis shuttle, complete the following steps:
Procedure
1. Read the safety information and installation guidelines, see “Safety” on page vii
and “Installation guidelines” on page 45.
2.
Turn off the server (see “Turning off the server” on page 41) and all attached
peripheral devices. Disconnect all power cords; then, disconnect all external
cables from the server.
3. Slide all of the components in the front of the server out slightly
4.
Remove all of the components from the rear of the server.
5. Remove the shuttle.
v
For the 4U server configuration , do the following:
a. Press the blue buttons on the interior wall of the shuttle to release the
shuttle cam handles and rotate the handles all the way down.
b. Grasp the shuttle with your hand through the hole on the center of the
shuttle and grasp the bottom of the shuttle with your other hand and
slide the shuttle out of the chassis.
v
For the 8U server configuration , do the following:
a. Press the blue buttons on the interior wall of the bottom node shuttle to
release the shuttle cam handles (do not rotate the handles down).
296
System x3850 X6 and x3950 X6 Types 3837 and 3839: Installation and Service Guide