IBM X3850 X6, Installation And Service Manual, Page: 286 / 1730

Storage book
9. Rotate the cam handle all the way up and push it into the server until it locks
in place.
10. Reinstall the drives in the front of the storage book.
11. Reconnect the power cord and any cables that you removed.
12. Turn on the peripheral devices and the server.
Removing the storage book board assembly
Use this information for instructions on how to remove the storage book board
assembly.
To remove the storage book board assembly, complete the following steps:
1. Read the safety information and installation guidelines, see “Safety” on page
vii and “Installation guidelines” on page 45.
2. Turn off the server (see “Turning off the server” on page 41) and all attached
peripheral devices. Disconnect all power cords; then, disconnect all external
cables as necessary to replace the device.
3.
Press the blue release button on the left EIA bezel of the storage book to
release the cam handle; then, lower the handle the way down.
4. Slide the storage book out of the server.
5.
Disconnect the cables from the adapters.
6. Disconnect the cables from the storage book board assembly.
7. Slide the assembly up and out of the slots on the storage book.
268
System x3850 X6 and x3950 X6 Types 3837 and 3839: Installation and Service Guide