IBM X3850 X6, Installation And Service Manual, Page: 245 / 1730

Replacing the half-length I/O book
This information provides instructions for replacing the half-length I/O book.
About this task
Note:
v
For notes and information that you must consider when install this I/O book,
see “Installing the half-length I/O book” on page 80.
v If you are replacing the half-length I/O book with a full-length I/O book, see
“Installing the full-length I/O book” on page 82.
To replace the half-length I/O book, complete the following steps:
Procedure
1. Reinstall the adapters (see “Installing an adapter” on page 84).
2. Close the adapter retention lever.
3. Align the I/O book with the I/O bay on the server and slide it into the server.
Release latch
Handle
Handle
Filler panel
.
4.
Rotate the handle all the way up and push it into the server until it locks in
place.
5. Reconnect any external cables to the adapters, if you removed any earlier.
6. Press the Power button on the I/O book to turn the power onto the adapter
slots. The Green LED will begin flashing. When the Green LED stop flashing,
the adapter is ready for use.
Chapter 6. Removing and replacing components
227