IBM X3850 X6, Installation And Service Manual, Page: 1701 / 1730

W.3808002 [W.3808002]
Explanation: An error occurred while saving UEFI settings to the IMM. Error Updating System Configuration to
IMM
Severity: Warning
User response: Complete the following steps:
1. Use F1 Setup, Verify and Save Settings to recover settings.
2. Reset the IMM.
3. AC cycle the system.
4. Check IBM support site for an applicable service bulletin or firmware update that applies to this error.
5. Reflash IMM Firmware.
6. Remove and re-install CMOS battery for 30 seconds to clear CMOS contents.
7. Replace the standard I/O book.
W.3808003 .[W.3808003]
Explanation: Unable to retrieve the system configuration from the IMM. Error Retrieving System Configuration
from IMM
Severity: Warning
User response: Complete the following steps:
1.
Use F1 Setup, Verify and Save Settings to recover settings.
2.
Reset the IMM.
3.
AC cycle the system.
4.
Check IBM support site for an applicable service bulletin or firmware update that applies to this error.
5.
Reflash IMM Firmware.
6. Remove and re-install CMOS battery for 30 seconds to clear CMOS contents.
7. Replace the standard I/O book.
W.3818005 [W.3818005]
Explanation: The CRTM flash driver could not successfully flash the staging area. The update was aborted CRTM
Update Aborted
Severity:
Warning
User response: Complete the following steps:
1. Continue booting system. If system does not reset, manually reset the system.
2. If the error is not reported on the subsequent boot, no additional recovery action is required.
3. If the event persists, continue booting system and reflash UEFI image. Check whether there are any additional
instructions to update to this level of UEFI.
4. Replace the standard I/O book.
W.3808002 • W.3818005
Appendix C. UEFI/POST error codes
1683