IBM X3850 X6, Installation And Service Manual, Page: 1694 / 1730

S.3050007 [S.3050007]
Explanation: A firmware fault has been detected in the UEFI image. Internal UEFI Firmware Fault Detected, System
halted
Severity: Error
User response: Complete the following steps:
1. Check IBM support site for an applicable service bulletin or firmware update that applies to this error.
2. Reflash UEFI image.
3. Replace the standard I/O book.
S.3058004 [S.3058004]
Explanation: A Three Strike boot failure has occurred. The system has booted with default UEFI settings. POST
failure has occurred! System booted with default settings.
Severity: Error
User response: Complete the following steps:
1. Original UEFI settings are still present. If customer desires to continue using the original settings, select Save
Settings.
2. If User did not intentionally trigger the reboots, check logs for probable cause. For example, if there is a battery
fault event, follow the steps to resolve that event.
3. Undo recent system changes (settings or devices added). Verify that the system boots. Then, re-install options one
at a time to locate the problem.
4. Check IBM support site for an applicable service bulletin or firmware update that applies to this error. Update
UEFI firmware if applicable.
5.
Remove and re-install CMOS battery for 30 seconds to clear CMOS contents. If it boots successfully, then restore
system settings.
6. Replace the standard I/O book.
S.3060007 [S.3060007]
Explanation: A firmware fault has been detected in the UEFI image. Internal UEFI Firmware Fault Detected, System
halted
Severity: Error
User response:
Complete the following steps:
1.
Check IBM support site for an applicable service bulletin or firmware update that applies to this error.
2.
Reflash UEFI image.
3.
Replace the standard I/O book.
S.3050007 • S.3060007
1676
System x3850 X6 and x3950 X6 Types 3837 and 3839: Installation and Service Guide