IBM X3850 X6, Installation And Service Manual, Page: 1691 / 1730

I.580A5 [I.580A5]
Explanation: Mirror Fail-over complete. DIMM number % has failed over to to the mirrored copy. DIMM Mirror
Fail-over Detected
Severity: Info
User response: Complete the following steps:
1. Check the system-event log for uncorrected DIMM failures and replace those DIMMs.
I.580A6 [I.580A6]
Explanation:
Memory spare copy has completed successfully. Spare Copy Complete
Severity: Info
User response: Complete the following steps:
1.
Check system log for related DIMM failures and replace those DIMMs.
S.1100B [S.1100B]
Explanation: CATERR(IERR) has asserted on processor %. Processor CATERR(IERR) has asserted
Severity: Error
User response: Complete the following steps:
1. Check IBM support site for an applicable service bulletin or UEFI firmware update that applies to this Processor
error.
2. Reboot system. If problem persists escalate to the next level of support.
S.1100C [S.1100C]
Explanation: An uncorrectable error has been detected on processor %. Uncorrectable processor error detected
Severity: Error
User response: Complete the following steps:
1. Check IBM support site for an applicable service bulletin or UEFI firmware update that applies to this error.
2. Reboot system. If problem persists escalate to the next level of support.
S.2011000 [S.2011000]
Explanation:
An Uncorrected PCIe Error has Occurred at Bus % Device % Function %. The Vendor ID for the device
is % and the Device ID is %. PCI PERR Detected
Severity: Error
User response: Complete the following steps:
1. Check IBM support site for an applicable device driver, firmware update, revision of service information for this
product or other information that applies to this error. Load new device driver and any required firmware
updates.
2. If this node and/or any attached cables were recently installed, moved, serviced or upgraded, a. Reseat Adapter
and any attached cables. b. Reload Device Driver c. If device is not recognized, reconfiguring slot to Gen1 or
Gen2 may be required. Gen1/Gen2 settings can be configured via F1 Setup -> System Settings -> Devices and I/O
Ports -> PCIe Gen1/Gen2/Gen3 Speed Selection, or the ASU Utility.
3. If problem persists, then remove Adapter Card. If system reboots successfully without the adapter, replace that
card.
4.
If problem persists, then replace the I/O book with the PCIe slot in question.
5.
If problem persists, then replace the compute book associated with the PCIe slot.
6. (Trained Service technician only) Replace the processor.
I.580A5 • S.2011000
Appendix C. UEFI/POST error codes
1673