IBM x3800 - System - 8865, Manual

Page: 153 / 196

a. Position the battery so that the positive (+) symbol is facing away from you.
b. Use one finger to press the top of the battery clip away from the battery.
c. Press the battery into the socket until it clicks into place. Make sure that the
battery clip holds the battery securely.
3. Install the I/O board (see “Replacing the I/O board” on page 140).
4. Install the top cover (tower model only) and lock the front cover (see “Replacing
the top cover, bezel, and front cover” on page 121).
5. Reconnect the external cables; then, reconnect the power cords and turn on the
peripheral devices and the server.
Note: You must wait approximately 20 seconds after you connect the power
cord of the server to an electrical outlet before the power-control button
becomes active.
6. Start the Configuration/Setup Utility program and reset the configuration:
v
Set the system date and time.
v Set the power-on password.
v
Reconfigure the server.
See “Using the Configuration/Setup Utility program” on page 158 for details.
Removing the CD drive
To remove a CD drive, complete the following steps.
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 115.
2. Turn off the server and peripheral devices, and disconnect the power cords and
all external cables necessary to replace the device.
3. (Tower model only) Remove the front cover (see “Removing the top cover,
bezel, and front cover” on page 119).
4. Press on the blue retention latches on each side of the drive and pull the CD
drive out of the server.
Chapter 4. Removing and replacing server components
137