IBM x 340 Series, Hardware Maintenance Manual

Page: 145 / 188

© Copyright IBM Corp. 2000
137
Related service information
Note: The service procedures are designed to help you isolate problems. They are
written with the assumption that you have model-specific training on all
computers, or that are familiar with the computers, functions, terminology,
and service information provided in this manual.
Safety information
The following section contains the safety information that you need to be familiar
with before servicing an IBM mobile computer.
General safety
Follow these rules to ensure general safety:
• Observe good housekeeping in the area of the machines during and after
maintenance.
• When lifting any heavy object:
1. Ensure you can stand safely without slipping.
2. Distribute the weight of the object equally between your feet.
3. Use a slow lifting force. Never move suddenly or twist when you attempt to
lift.
4. Lift by standing or by pushing up with your leg muscles; this action removes
the strain from the muscles in your back. Do not attempt to lift any objects that
weigh more than 16 kg (35 lb) or objects that you think are too heavy for you.
• Do not perform any action that causes hazards to the customer, or that makes the
equipment unsafe.
• Before you start the machine, ensure that other service representatives and the
customer's personnel are not in a hazardous position.
• Place removed covers and other parts in a safe place, away from all personnel,
while you are servicing the machine.
• Keep your tool case away from walk areas so that other people will not trip over
it.
• Do not wear loose clothing that can be trapped in the moving parts of a machine.
Ensure that your sleeves are fastened or rolled up above your elbows. If your hair
is long, fasten it.
• Insert the ends of your necktie or scarf inside clothing or fasten it with a
nonconductive clip, approximately 8 centimeters (3 inches) from the end.
• Do not wear jewelry, chains, metal-frame eyeglasses, or metal fasteners for your
clothing.
Remember: Metal objects are good electrical conductors.
• Wear safety glasses when you are: hammering, drilling soldering, cutting wire,
attaching springs, using solvents, or working in any other conditions that might
be hazardous to your eyes.
• After service, reinstall all safety shields, guards, labels, and ground wires.
Replace any safety device that is worn or defective.