IBM X 330 Series, Installation Manual, Page: 27 / 76

Chapter 2. Installing options
15
8. If you have other options to install, install them now. Otherwise, continue with
“Installing the cover”.
Installing the cover
Complete the following steps to install the server cover:
1. Clear any cables that might impede the replacement of the cover.
Important: Before sliding the cover forward, make sure that all of the tabs on the
cover will engage the ledge at the front of the server properly. If all the tabs do not
engage the ledge properly, it will be extremely difficult to remove the cover later.
2. Install the cover by placing it into position and sliding it forward. Make sure that
the cover engages the tabs at the front and rear of the server.
3. Install the screws and secure the cover as shown.
4. Install the server in the rack. See “Rack installation considerations” on page 16
and see the Rack Installation Instructions that come with your server.
5. Continue with “Working with cables” on page 16 for the instructions needed to
cable the server.
Clip
Heat sink
Microprocessor
Terminator card
Heat sink release
lever
Slot
Top view of
heat sink
Screws