IBM WebSphere DataPower 7198, Installation And User Manual

Page: 55 / 88

DataPower Hardware Diagnostics Tool Version 1.0
(C) Copyright 2011 - IBM Corporation
Main Menu:
1. Inventory n/a
2. BMC/Sensors n/a
3. Network n/a
4. Memory n/a
5. Disks n/a
0. Exit Diagnostics
Select action>
5.
To select a test to run, enter its number at the
Select action
prompt.
Note: The diagnostics user interface can differ depending on your firmware
release.
After completing a test, the diagnostic self-test produces one of the following
results:
v PASS
v FAIL
v SKIP
v RUNNING
v SKIP
v n/a
Viewing status providers for sensors
The DataPower appliance provides the following sensors status providers:
Fan speed sensors
Provides the measured speed in revolutions per minute (RPM) for each of
the fans in each fan module.
From the WebGUI, click STATUS
→
System
→
Fan Sensors .
From the command line, enter show sensors-fans .
Temperature sensors
Provides the measured temperature in degrees Celsius for internal
components:
v
Temperature of each of the two internal CPU components
v
Temperature of each of the two internal inlet air temperatures
v
Temperature of each of the two internal system components
From the WebGUI, click STATUS
→
System
→
Temperature Sensors .
From the command line, enter show sensors-temperature .
Voltage sensors
Provides the measured voltage for the internal components.
From the WebGUI, click STATUS
→
System
→
Voltage Sensors . The voltage
is measured in volts.
From the command line, enter show sensors-voltage . The voltage is
measured in millivolts.
Chapter 5. Diagnosing your appliance
35