IBM Universal Tape Library, User Manual, Page: 57 / 96

Installing a magazine
To install a magazine, complete the following steps:
1. Secure the handle to the magazine, using the three Phillips screws.
2. Install the tapes in the magazine.
3. Install the magazine in the library chassis.
4. Close the front doors.
Removing a tape drive
To remove a tape drive, complete the following steps:
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 7.
2. Turn off the tape drive power:
a. From the main screen, press the Ops button.
b. From the Ops menu, press the Down button (
↓
) to select Drive operations ,
and press the Enter button. The Drive operations menu is displayed.
c. Press the Down button to select the tape drive, and press the Enter button.
d. Press the Down button to select Pwr off , and press the Enter button.
3. Loosen the captive screws that secure the tape drive.
4. Pull on the tape drive handle to remove the tape drive.
Installing a tape drive
To install a tape drive, complete the following steps:
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 7.
2. Make sure that the library is turned off and that the power cord is disconnected.
3. Slowly insert the tape drive into the library chassis until the connectors are fully
seated.
Tape drive handle
Tape drive
thumbscrews
Figure 21. Removing a tape drive
Chapter 6. Removing and replacing library components
47