IBM TURBOWAYS 622 PCI MMF ATM, Installation And Using Manual

Page: 31 / 44

Chapter 8. Connecting the TURBOWAYS 622 PCI MMF ATM Adapter
to the Network
This chapter provides instructions for connecting the network cables and the adapter.
Refer to your local procedures for information about connecting the TURBOWAYS 622
PCI MMF ATM Adapter to your ATM network.
Note: The connector on the adapter conforms with the ATM Forum standard. If your
switch connector pinout is not compatible with this standard, obtain or create a
cable that conforms to this standard.
Connecting the Network Cables and Adapter
Make sure you have read “Chapter 2. Preparing for Installation” on page 3 before you
begin connecting the adapter.
To connect the adapter to a multimode fiber network, do the following:
1. Insert the male SC Fiber Optic connector on the fiber cable into the adapter SC
connector.
2. Insert the male SC Fiber Optic connector on the other end of the cable into the
network switch.
23