IBM Turbo 16/4 Token-Ring PC Card 2, User Manual

Page: 44 / 123

2. Configure the PC Card.
Memory management notes
v
If you are using Card and Socket Services, the program will default to
Autoset mode, which allows the LAN driver to negotiate with Card and Socket
Services for available resources. LANAID will allow you to select values for
resources to be used by your PC Card such as Interrupt, memory, and I/O
Base Address.
v
If you are not using Card and Socket Services in Autoset mode, you must
ensure that the values that you select for Interrupt, MMIO, and SRAM do not
conflict with those for other PC Cards and resources installed in your
computer (such as video, sound, COM port).
v
If you are using EMM386, in most cases the memory exclusions will be
automatically handled by LANAID. If you are using a memory manager, you
must exclude the memory ranges being used by your PC Card (8-KB
default).
a. If LANAID is not already installed, install it as described in “Installing
LANAID” on page 33.
b. After LANAID is installed, continue with “Using LANAID to Configure the PC
Card” on page 34. When you get to the panel that asks for the existing
network operating system, select Microsoft Windows for Workgroups.
3. Step 5 of the Installation Checklist is now complete. Continue with the next step
on page 3.
ODI 16–bit Client
Note: It is recommended that you use LAN Client (Client32) whenever possible as
an efficient solution.
The 16–bit DOS Novell NetWare Requester environment supports access to servers
running Novell NetWare 3.11 or higher.
To install the TOKENCS.COM ODI driver on a DOS computer, perform the following
steps. Consult your Novell NetWare documentation for instructions regarding how to
create the NetWare Client for DOS and MS Windows diskettes.
1. Create a diskette containing the extracted files from the DOSODI.EXE file on
the IBM Turbo 16/4 Token-Ring PC Card 2 CD-ROM.
2. Insert the NetWare Client for DOS and MS Windows Disk 1 into the
appropriate drive.
3. At the command prompt, type a:, where a is your drive letter, and then press
Enter.
4. Type install and then press Enter.
5. Follow the instructions as they appear. In step 5 of the instructions, press
Enter and select Other Drivers.
6. Insert the CD-ROM or the diskette that you created in step 1 into the
appropriate drive. When prompted, specify the location to the chosen media
and press Enter. Specify the path as a:\novell\dos (or x:\novell\dos for the
CD-ROM version).
7. Highlight your adapter and press Enter.
8. At this time you can change the default parameters. When you finish making
any desired changes, press F10. “ODI 16–bit Client Parameters” on page 29
contains the parameters that can be configured in the NET.CFG file.
28
Turbo 16/4 Token-Ring PC Card 2