IBM TS7650G PROTECTIER DEDUPLICATION GATEWAY, User Manual, Page: 79 / 248

Table 14. ListReplicationDestinationDirectoryStatistics command (continued)
Command Explanation Command Specific Options
Example:
ListReplicationDestinationDirectoryStatistics
►► ./ptcli ListReplicationDestinationDirectoryStatistics --ip 9.148.220.45 --loginFile h:\ptcli\ptadmin --fsName <name> ►◄
CIFS related commands
Table 15. AddSambaUser command
Command Explanation Command Specific Options
AddSambaUser Add a Samba user (note
that this command may
only be used in Workgroup
authentication mode Name Explanation
--name <NAME> Samba usenername
--password PASSWORD Samba user password
[--uid ID] User ID
Example:
AddSambaUser
►► ./ptcli AddSambaUser --ip 9.148.220.45 --loginFile h:\ptcli\ptadmin Command Specific Options ►◄
Command Specific Options:
--name <NAME> --password <PASSWORD>
[--uid] <ID>
Table 16. ChangeSambaUserEnablement command
Command Explanation Command Specific Options
ChangeSambaUserEnablement
Update enablement Name Explanation
--name <NAME> Samba username (taken
from "ListSambaUsers"
output).
--enablement <STATUS> User's enablement status
(valid values are enable,
deactivate).
Example:
ChangeSambaUserEnablement
►► ./ptcli ChangeSambaUserEnablement --ip 9.148.220.45 --loginFile h:\ptcli\ptadmin Command Specific Options ►◄
Command Specific Options:
--name <NAME> --enablement <ENABLE or DEACTIVATE>
Chapter 8. Managing and monitoring ProtecTIER through the CLI
59