IBM TS7650G PROTECTIER DEDUPLICATION GATEWAY, User Manual, Page: 75 / 248

ProtecTIER repository commands
The following tables contain lists of commands to invoke on the ProtecTIER
repository.
Table 5. CreateRepository Command
Command Explanation Command Specific Options
CreateRepository
Create a repository Name Explanation
--name <NAME>
Repository name
--system <NAME> System name
--size <SIZE> Repository physical
maximum size in TB
--peak <NUM>
Peak throughput in MB
--ratio <NUM>
Deduplication ratio
--raid <X,Y,Z>
Metadata raid configuration
in the form of [X,Y,Z]
where (X = Type), (Y =
Members) and (Z = Disk
size in GB) taken from
"RaidConfiguations" output
[--metadata
<MOUNT_POINTS>] List of GFS (global file
system) mounted file
systems used to store
ProtecTIER repository
metadata
[--userdata
<MOUNT_POINTS>]
List of GFS mounted file
systems used to store
ProtecTIER repository user
data
Example:
CreateRepository
►► ./ptcli CreateRepository --ip 9.148.220.101 --loginFile h:\ptcli\ptadmin Command Specific Options ►◄
Command Specific Options:
--name PTCLI_REP --system PTCLI_SYS --size 2 --peak 300 --ratio 13 --raid FC-10K,4+4,120 Command specific options
Command specific options:
--metadata <MOUNT_POINTS> --userdata <MOUNT_POINTS>
Table 6. RaidConfigurations Command
Command Explanation
RaidConfigurations
Prints information about the supported raid
configurations
Chapter 8. Managing and monitoring ProtecTIER through the CLI
55