IBM TotalStorage L10, Cli Reference Manual

Page: 62 / 96

2006 Model L10 Storage Switch
50
To view the LIM port for a specific zone:
From the Diagnostics menu (root/diag), type
glim <zone number>
and press E
NTER
.
Displaying detected ordered sets (root/diag/os)
This command displays the detected ordered sets for a single port or for all ports.
To view the detected ordered sets for all ports:
From the Diagnostics menu (root/diag), type
os
and press E
NTER
.
To view the detected ordered sets for a specific port:
From the Diagnostics menu (root/diag), type
os <port number>
and press E
NTER
.
A list of detections and their indications follows:
Table 26. Detected ordered sets
Detection Indication
User Match The ordered set or pattern selected under the Match area
has been detected.
EOF (End of Frame) An End-of-Frame (EOF) delimiter has been detected;
frames are present. (An EOF immediately follows the CRC
of a frame and signals the frame’s end.)
SOF (Start of Frame) A Start-of-Frame (SOF) delimiter has been detected;
frames are present.
Idle Sequences of IDLEs are being transmitted to maintain link
activity; no other data is being transmitted.
ARBFF ARB(FF)s are being transmitted to maintain link activity; no
other data is being transmitted.
ARB A port is arbitrating for network access to perform a task.
RRDY (Read Ready) The receiving node on this port has sent an R_RDY signal,
indicating that it is ready for a frame to be transmitted over
the link.
CLS (Close) The port is attempting to begin the process of closing the
current FC-AL circuit.
OPN (Open) The port is attempting to open communications with another
port.
Note: As is the case with some ordered sets, an OPN may
not go all the way around the FC-AL, instead
stopping at its destination.