IBM TotalStorage L10, Cli Reference Manual

Page: 31 / 96

Chapter 2. Configuration menu (root/config)
19
Configuring the event log severity fault threshold
(root/config/sys/fault)
This command sets the threshold for when the Fault LED is triggered by an event. When
set, an event that is equal to or higher than the specified fault threshold will trigger the
switch’s Fault LED. The default setting is 3.
Each event has a particular severity level ranging between ‘emergency’ and ‘info’. Users
can designate the lowest severity level at which to trip the switch’s Fault LED.
To change the event log severity level:
1. From the System Configuration menu (root/config/sys), type
fault
and press E
NTER
.
The current fault threshold value appears in brackets before the command prompt.
2. Type the desired selection (
1-7
) and press E
NTER
.
Clearing the event log (root/config/sys/evclr)
This command deletes all event log messages currently recorded in the log.
To delete the current list of event log messages:
1. From the System Configuration menu (root/config/sys), type
evclr
and press E
NTER
.
A message prompt appears confirming the request.
2. Type
y
and press E
NTER
.
The event log is cleared out and a new event message appears reporting the cleared
event log.
Clearing the fault LED (root/config/sys/clrled)
This command clears the switch’s fault LED.
To clear the switch’s fault LED:
From the System Configuration menu (root/config/sys), type
clrled
and press E
NTER
.
The Fault LED turns off.
Table 12. Event log severity fault threshold settings
Setting Description
1 emergency
2 alert
3 critical
4 error
5 warning
6 notify
7 info