IBM TotalStorage L10, Cli Reference Manual

Page: 29 / 96

Chapter 2. Configuration menu (root/config)
17
To exit the setup menu:
Type
7
and press E
NTER
.
The following table provides a list of the system log messages and their severities.
6. Severity
Threshold The lowest severity level at which to send messages to the system log
server. Any messages that are equal to or higher in severity than the
specified severity level are sent to the system log server. For example,
if the severity level for system log reporting is designated as ‘alert’, the
switch logs messages of the ‘alert’ or the ‘emergency’ severity level
only—’emergency’ is the only severity level higher than ‘alert’. The
default setting is 6 (‘info’).
The severity levels include:
0 – emergency
1 – alert
2 – critical
3 – error
4 – warning
5 – notify
6 – info
7 – debug
7. Exit Setup Exits the setup menu.
Table 10. System log server messages and severities
Message Severity
SFP Overvoltage. CRITICAL
Port # inserted. INFO
Port # bypassed. INFO
Temperature Over Max. ALERT
Temperature OK. INFO
Port # state change to Unknown. INFO
Port # state change to Inserted. INFO
Port # state change to Loopback. INFO
Port # state change to Byp-Tx Fault. INFO
Port # state change to Diag Transmit. INFO
Port # state change to Byp-LIP(f8,x). INFO
Port # state change to Byp-Timeout. INFO
Port # state change to Byp-Redundant. INFO
Port # state change to Byp-Rx LOS. INFO
Port # state change to Byp-Sync LOS. INFO
Port # state change to bypassed. INFO
Table 9. Switch settings for a system log server (continued)
Setting Description