IBM TotalStorage IP Storage 200i 110, Installation Manual

Page: 28 / 94

To install a memory module (DIMM):
1. Review the safety precautions listed in Statement 1 and Statement 5 in
“Appendix C. Safety notices” on page 47.
2. Review the documentation that comes with your DIMM.
3. Power OFF the appliance and peripheral devices, and disconnect all external
cables and power cords.
4. If you are replacing a DIMM, remove the defective DIMM by pulling it firmly out
of the connector.
5. Touch the static-protective package containing the DIMM to any unpainted
metal surface on the appliance, and remove the DIMM from the package. This
discharges any static electricity from the package and from your body.
6. Ensure that the DIMM retaining clips are in the open position.
Note: Handle the retaining clips gently to avoid breaking them or damaging
the DIMM connectors.
1
DIMM 1
2
DIMM 2
3
DIMM 3
4
DIMM 4
5
Retaining clip
Figure 3. Installing a DIMM
16
IBM TotalStorage IP Storage 200i Models 110 and 210 Installation Guide