Chapter 2. Installing the storage server
15
Installing the storage subsystem configuration
Using the information gathered in the previous sections, install the host systems and
host adapters.
Notes:
1. Refer to the documentation provided with your host adapters for installation
requirements and procedures.
2. Use the correct host adapter driver. For the latest supported host adapters and
drivers, go to the following Web site: http://www.ibm.com/pc/support
Attach fiber-optic interface cables to each host adapter. You will connect the other end
of the cables to the controller later in the installation process. For more information
about handling fiber-optic cables, see “Installing fiber-optic cables” on page 19.
Note:
Do not install the storage-management software at this time, if it is not already
installed. Install the storage server completely before installing the software,
because you cannot test the software installation until the hardware is
connected.
Getting started
Use the following list to prepare a storage server for installation:
1. Prepare the site to meet all area, environmental, power, and site requirements.
For more information, see “Operating specifications” on page 7.
2. Move the storage server and its rack cabinet to the site.
3. Remove the storage server from its shipping container and check the contents
(for a list of items, see “Inventory checklist” on page 3.) If any items are missing,
contact your IBM reseller before proceeding.
4. Assemble the tools and equipment that you will need for installation. These might
include:
• Power cords (come with the storage server)
• Screwdrivers (various sizes)
• Antistatic protection (such as a grounding wrist strap)
• Gigabit Interface Converters (GBICs)
• Fibre Channel and Ethernet interface cables and cable straps
• Rack-mounting hardware (comes with the storage server)
• Storage-management software to configure the storage subsystems (comes
with the storage server on the
Netfinity FAStT Storage Manager Version 7.02
installation CD.)
5. Install the storage server in the rack. Rack mounting instructions and a template
for aligning the holes in the rails and the rack, come with the storage server. If you
have misplaced these items, see Appendix B, “Rack mounting template and
instructions,” on page 71.
6. After you install the storage server in the rack, go to Chapter 3, “Cabling the
Summary of Contents for TotalStorage FAStT200
