IBM TotalStorage DS4500, User Manual

Page: 51 / 122

Attention: Pulling the cover out too far can damage the plastic hooks at the top.
To avoid damaging the hooks, place the DS4500 Storage Server on a flat surface.
Be sure the front of the DS4500 Storage Server extends beyond the edge
approximately 5 cm (2 in.).
1. Carefully pull the bottom of the bezel out to release the pins. Then slide the
bezel down as shown in Figure 21.
2. To replace the bezel, slip the top edge of the bezel under the lip on the chassis,
then push the bottom of the bezel until the pins snap into the mounting holes,
as shown in Figure 22 on page 22.
Figure 21. Removing the DS4500 Storage Server bezel
Chapter 2. Operating the DS4500 Storage Server
21