IBM TotalStorage 3494 Tape Library, Operator'S Manual

Page: 441 / 605

Access to Additional Information
You can access the following additional information:
v
User assistance provides the following:
– An overview of the PtP VTS system
– Descriptions of the information provided on the various screens
– A glossary of terms
v
Online access to documentation
This publication and those listed below are available over the Internet at the
IBM Publications Center, accessible through the IBM Website:
– IBM TotalStorage 3494 Tape Library Introduction and Planning Guide
– IBM TotalStorage 3494 Tape Library: Planning, Implementing, and Monitoring
– IBM TotalStorage Peer-to-Peer Virtual Tape Server Planning and Implementation
Guide
v
Links to the Specialist home pages (see “IBM TotalStorage 3494 Tape Library
Specialist” on page 42)
Cartridge Removal from the Gripper
Some operator intervention conditions require you to remove a cartridge from the
gripper. Figure 264 on page 416 shows the picker and the gripper assembly.
Perform the following steps to remove the cartridge from the gripper:
1.
If the 3494 Tape Library is not already in Pause mode, press the
Pause
push
button on the operator panel.
2. Open the front door of the 3494 Tape Library in front of the cartridge accessor.
3. Rotate the picker
1
so that it is pointing toward the right side of the device,
parallel to the rails
3
.
4. Push the reach assembly
5
out so that it is extended fully.
5. Press the top
2
of the gripper assembly to release the cartridge
4
.
6. Push the reach assembly in so it is retracted fully.
7. Close the front door.
8.
Press the
Auto
push button on the operator panel to return the 3494 Tape
Library to Auto mode.
Chapter 6. Advanced Operating Procedures
415