IBM TotalStorage 3494 Tape Library, Operator'S Manual

Page: 379 / 605

Library Location Name
Specifies the remote location name (of the Library Manager) with which
the host communicates.
The Common Programming Interface (CPI) - Communications
partner_LU_name of the Library Manager, consists of the network
identifier and the location name. For example, if the Library Manager
partner_LU_name is USIBMSU.LIBMGRC3 , then the Library Manager
Location Name is LIBMGRC3 .
Library Adapter Address
Specifies the LAN adapter address of the remote controller (the Library
Manager). This can be the Library Manager adapter card universally
administered address (UAA), such as 10005A8A5E75, or a locally
administered address (LAA), such as 40003494001A.
Library IP Address
The Library Manager IP Address is the unique Internet address assigned to
the Library Manager.
Library Host Name
The Library Name is the Hostname defined in the TCP/IP network for the
Library Manager. In Figure 227 on page 352, libmgrc3.ibm.com is a
TCP/IP Hostname.
The Library LAN Information window has the following push buttons:
OK Closes the Library LAN Information window.
Help Provides help about the Library LAN Information window.
Operator Intervention
Certain conditions in the 3494 Tape Library, when detected, require short-term
operator intervention to resolve. These conditions do not stop the Library Manager
from accepting commands but can delay the execution of certain queued
operations. See Chapter 8, “Problem Determination Procedures,” on page 433 for
most conditions that require intervention.
The Library Manager keeps track of the outstanding intervention-required
conditions. These conditions can be displayed on the Library Manager console, and
you can indicate the conditions that you have resolved. Steps are provided to
resolve each condition. For instructions on removing a cartridge from the gripper,
see “Cartridge Removal from the Gripper” on page 415.
Note: You can view operator intervention information from the Specialist (see
“Specialist Features and Functions” on page 396).
The Operator Intervention window (Figure 228 on page 354) displays the list of
conditions and the priority assigned (the priorities are 1 , 2 , and 3 ; priority 1 is the
highest, and priority 3 is the lowest. If no outstanding conditions exist, the list is
blank.
1.
Determine what condition to resolve, perform the necessary action, then
indicate that you resolved the condition by highlighting the condition and
selecting the OK push button. You can also select the Help push button for the
operator actions.
Note:
Chapter 6. Advanced Operating Procedures
353