IBM TotalStorage 3494 Tape Library, Operator'S Manual

Page: 337 / 605

1. Enter the IP address in the Pri Addr: field (for the Primary EKM) or Alt Addr:
field (for the Alternate EKM).
2.
It is not usually necessary to change the default port number, 03801. However,
in the event of a port conflict, you can enter another value.
3. Select Modify IP Information .
The Key Label Entry and EKM IP Information window provides the following
push buttons:
Add Key Label
Adds the Key Label that is in the entry field.
Delete Key Label
Deletes the Key Label that is in the entry field.
Modify IP Information
Add or change the IP Addresses and Port info for the LME Key Manager.
Refresh
Refreshes the Key Label Entry and EKM IP Information window.
Exit Exit from the Key Label Entry and EKM IP Information window.
Help Access online help for the Key Label Entry and EKM IP Information
window.
LME: Drive Encryption Settings
The LME: Drive Encryption Settings window is used to change the encryption
settings for one or more encryption-capable drives. Only system administrators can
access this panel.
The drives can be open-system drives, or control unit attached drives. Note: For
open-system, the settings are established via the library prescribed methods such
as the IBM System Storage Tape Library Specialist Web interface in the TS3500. For
Control Unit attached, the Library Manager sends the SET_VPD Message directly
to the drive to change encryption setting. .
Note: You can also view or change the LME drive encryption settings from the
3494 Tape Library Specialist. Select Administer Library Manager, Manage
Encryption, then select Drive Encryption Settings from the menu.
(See“Specialist Features and Functions” on page 396.)
Chapter 6. Advanced Operating Procedures
311
|
|
|
|
|