IBM TotalStorage 3494 Tape Library, Operator'S Manual

Page: 297 / 605

Exit Closes the Stacked Volume Pool Properties window.
Help Provides help about the Stacked Volume Pool Properties window.
Move/Eject Stacked Volumes
Note: You can view the Move/Eject Stacked Volumes window from the Specialist
(see “Specialist Features and Functions” on page 396).
The Move/Eject Stacked Volumes window (Figure 172 on page 272) allows you to
move and eject stacked volumes. The VTS must be at code level 2.26.1.0 or higher
and the Library Manager must be at code level 527 or higher to perform this
function. Note that when moving or ejecting stacked volumes that contain active
data, the active data is retained in its current pool.
Note: The 3590 and media types J and K are not supported for the TS7700
Virtualization Engine.
The following actions can be performed on the Move/Eject Stacked Volumes
window:
v
Move a range of volumes to another pool
v Move a range of scratch only volumes to another pool
v
Move a quantity of scratch only volumes to another pool
v Move logical volumes stored on range of stacked volumes to a target pool
v
Eject a range of volumes
v Eject a range of scratch only volumes
v Eject a quantity of scratch only volumes
v
Cancel active move requests
v Cancel active eject requests
a06c0433
Figure 171. Stacked Volume Pool Properties History Details
Chapter 6. Advanced Operating Procedures
271